• Kennel and run with an apex roof
  • Tongue and groove shiplap
  • Kennel with floor and a diameter of 1.8 x 1.2m
  • Run area of 1.8m x 1.8m
  • Internal stable door to access kennel with hinged pop hole (305x480mm)
  • Run is supplied without a floor for all hygiene purposes
  • Galvanised steel mesh on run

Size Code: Estimate size in feet, for example 1006 = approximately 10ft x 6ft.

Size L x W x H: Length x Width (door end) x Height (top of the apex) in m (metres).

Door W x H: Width x Height of the door in mm (millimetres). Please note, that the door gap is moderately smaller than the door itself.

Floor Plan: Select by size from the above table. These show the measurements of the floor along with the joins and the direction of the floor joists. Please note, that the direction of the floor joists can change so this must be checked before an order is placed, if critical.

Assembly Guides: Select by size from the above table. Please note that due to the amount of sizes, models and variations that we offer, the assembly guide may not be 100% specific to your kennel and run, but it should provide you with all the necessary principles.

Eaves Height: Internal height at the stunted point of the roof (sides).

Lock: This kennel and run comes with a tower bolt, which keeps the doors closed but does not lock them.

Roof cover: Supplied with high quality polyester-based roofing felt.


Building Sizes
All sizes are an estimate and are based on the external measurements (unless stated contrarily) – they also do not encompass roof overhang. Please allow for any overhangs when choosing the size of your timber building, whilst also bearing in mind, the recommended space for installations and upkeep of your timber building. We advise you also check internal sizes when buying a timber building for a specific purpose, or any other sizes if critical. Planning permission may also be needed on some buildings depending on size and location, please check with your local council if unsure.